The drawing or presentation files are copied during the iCopy operation. dwg) or presentation (.ipn) files can be attached to the iCopy template using the iCopy Author. During the iCopy command, parts can be set to copy or reuse depending on the definition and purpose.ĭrawing (.idw. Each assembly (iCopy result) can vary from other iCopy results in the pattern depending on the adaptivity that was used in the iCopy template. The iCopy command creates one or multiple copies of the iCopy template and adds each copy to the target assembly. Other parts in the template assembly can include the layout, other derived parts, and other non-derived parts. Constrain any part that does not derive its position from the layout to other parts in the template assembly.Use a flush constraint to constrain each of the origin planes (XY/XY, YZ/YZ, and XZ/XZ). Constrain the origin of each part derived from the layout part to the iCopy template layout part origin.Constrain the iCopy template layout part origin to the iCopy template assembly origin.The skeleton assembly can contain derived parts that change shape and static parts that are referenced by each iCopy result.Ĭonstrain the skeleton assembly in a particular way for best results with adaptivity. Insert additional parts into the skeleton assembly.The derived geometry forms the basis for solid geometry and additional detail in the child parts. The shape/sketch geometry is derived from the layout into other part documents. Creating parts derived from a layout part is the basis of skeletal modeling. Create each additional part for the iCopy template by deriving the part from the layout part.Use adaptivity to change the skeleton model and verify that it updates as expected. Test the layout part by placing the skeleton assembly in a test assembly. Create and test the template layout part.For best results, do not fully constrain sketch geometry. Note: Fully constrained sketch geometry can cause problems with adaptivity. Each iCopy result contains the iCopy definition, so any iCopy result can be used as an iCopy template. Use the iCopy command to create one or more iCopy results.This results in an iCopy template containing the iCopy definition. Use the iCopy Author command in the assembly to enable it as an iCopy template.Create a skeleton assembly, including the template layout part containing sketch geometry, and parts derived from the skeleton template layout/shape. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |